![]() |
Anybody ever seen these seats?
Hi all, I have been looking on this site for a couple of weeks because I have been looking to by a H2, well I finally found one I like, but had a question. I have been researching these things pretty extensively and have never seen the interior that is in the one I am about to buy was wondering if it is custom or special edition? Thanks for the help mike.
![]() ![]() |
Re: Anybody ever seen these seats?
that would be custom i believe
|
Re: Anybody ever seen these seats?
oh and welcome to the forum :beerchug:
|
Re: Anybody ever seen these seats?
Yes, those are custom. They look similar to the ones Lynch had in their limited edition Victory Edition H2 three years ago. If that's the machine, it looks like it has 37" tires on it. You're going to be much happier if the put in a higher axle ratio.
|
Re: Anybody ever seen these seats?
Thanks for the replies. Those are 38 on it, I am not to fond of the rims but eaisly swaped out. I don't know what gearing it has but it seemed to have more pick-up than a stock one I drove so I think its geared by the assometer anyway.
|
Re: Anybody ever seen these seats?
either a roadwire seat kit or a katzkin kit!!!
|
Re: Anybody ever seen these seats?
May want to double check the heated seats work... The heating element is sewn into the leather. Either that is a factory middle section sewn in hopefully with the heater element still working or aftermarket which may not have the heated option on them...
|
Re: Anybody ever seen these seats?
Quote:
Thanks for the heads up. It's weird the front seats work but the rear seats don't, guess they didn't want to spend the money for the rear. |
Re: Anybody ever seen these seats?
You can have an aftermarket heat element placed in the seats and hooked up to the factory switch so would not be a deal killer for me, just a negotiation point...
|
Re: Anybody ever seen these seats?
I would bet a very large sum they are Katzkin, simply by looking at the pocket behind the drivers seat. I have Katzki in my truck and it looks the same.
As far as the heating elements with a Katzkin kit you have three options from my searching: go without, install factory elements with Katzkin kit, or use an aftermarket kit which may or may not work with factory controls. I chose to utilize the existing factory which are stitched into the oem seats so they have to be cut out--huge pain for my instatller. They do not get as hot as the oem setup, but they do the job. |
Re: Anybody ever seen these seats?
I smell spam cooking.... three of the links in their sig don't work :raar:
Quote:
|
All times are GMT +1. The time now is 07:03 AM. |
Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.