Anyone purchase the clearmask products for the front of the rear fender flares? If so, did you receive four cutouts and did they fit ok when doing a dry fit?
I received these a few months ago, then put off installing until my hand was healed. Now, I'm trying to test fit these to the Hummer and they do not appear to fit.
I have tried writing the company in TX; Clearmask, and they do not seem to answer emails. Appears customer support might be non-existent.
Anyone?

Anyone purchase the clearmask products for the front of the rear fender flares? If so, did you receive four cutouts and did they fit ok when doing a dry fit?
I received these a few months ago, then put off installing until my hand was healed. Now, I'm trying to test fit these to the Hummer and they do not appear to fit.
I have tried writing the company in TX; Clearmask, and they do not seem to answer emails. Appears customer support might be non-existent.
Anyone?

Please keep up posted on this as I was planning on getting the Clearmask for the fenders too.

I'd like to know how the DIY installation goes. I'm very cautious about anything that's self-adhesive since a bad experience with a wood dash trim kit a few years ago.

I applied similar products to my Vettes, and no problem. These are strange, and so far, Clearmask refuses to answer any emails. Tomorrow, I will call.
I received four and from my preliminary fitting, neither fits the front of the rear fender flare.
I would have to say beware of this place, since they refuse to answer any emails.

Can anyone suggest a better product or dealer to get protection for the fenders?