View Single Post
  #7  
Old 11-29-2002, 02:25 PM
Gary Gary is offline
 
Join Date: Nov 2002
Location: Finlayson, Minnesota, USA
Posts: 112
Gary is off the scale
Default

Aruba,

You will have to get your H2 in the air or use a creeper to get under your H2. You will see the oil filter is located near the drivers gas pedal if you were sitting in your H2 and had super human abilities to see through the floor. Once, underneath your H2. The wonderful skid plat protection may conceal your blue oil filter. You'll need an oil wrench to remove the filter. But first be sure to drain your oil out of the oil pan by removing your drain plug. Have a container to put your used oil in and bring it an oil recycling facility. Don't do what we used to do 20 plus years ago and dump in a sewer drain. This is a big NO NO. You should be able to by from the Chevy dealer on the Island both your filter and oil from them at cost. If not, I can't remember on the Island if you have a NAPA auto parts store but you can also get it there. Be sure to lubricate your oil filter gasket on the oil filter with some new oil using your finger. This will allow for the rubber gasket not to seat to the oil filter fitting on your engine improperly so that when you remove it for your next oil change your don't get pieces of your filter stuck to your engine.

Good Luck!!!


Finlayson, MN

Gary
__________________
Respectfully yours,


Gary
Finlayson, MN

www.FinancingYourHome.com/MyH2HUMMER.htm

www.FinancingYourHome.com
Reply With Quote