H2Dude,
When you take out the center console there are two screws in the front of it that attach the center console to the radio bezel. They are hard to see in the post by Happy Jack but they are there...up under the console lip a bit. The two hex bolts you see in the radio bezel are the other two item you need to remove. From there, there are only pressure clips that hold the top of the radio bezel level with the dash board.
To recap:
1) Remove center console. Make sure you get the two foward most screws that attach the console to the radio bezel.
2) Pull center console back about 1-2 inches.
3) Remove two hex bolts in radio bezel.
4) Pull straight back on radio bezel.
Once this is done you will easily see three screws that hold in the radio.
I removed the glove compartment to allow room to route the IP-Bus wire up under dash.
Hope this helps!!
|