View Single Post
  #8  
Old 12-21-2005, 03:20 PM
KenP's Avatar
KenP KenP is offline
Hummer Messiah
 
Join Date: Apr 2003
Location: Virginia Beach
Posts: 37,474
KenP is an unknown quantity at this point
Default

There may be some product you need to trim in order to get the strip to mount all the way down. Just use a razor knife and cut it away.

Put the bars back on and tighten down with the Torx bolts making sure the sides are even.

Lubricate the lock mechanism while you have the lock off. (You might as well. They get tough to turn.) If there is product on the very ends of the rails, you will need to use the razor knife to cut it off. You only need to clean the bottom half of the end to get the lock to function properly. This only takes a few seconds.

The lock should slide on and work now.

That's it.

Piece of cake.
Attached Images
 
__________________
"My reading of history convinces me that most bad government results from too much government."---Thomas Jefferson
Reply With Quote