So, my Gobi is on it's way. Gonna remove the cross bars and give the top another (it has 3 already) coats of wax, BEFORE I get the Gobi up there.
So trying to remove the plasic pieces @ the back end of the truck so I can slide the cross bars off the back end. Pulling the little tab towards the front of the truck and using the little access hole to pull, it moves, minimally. If I get a screwdriver in there on the tab, I can pry up a little more, but I swear I'm gonna bust something. I've tried on both sides and at least they are consistently difficult.
This thread says just yank 'em out.
http://elcova.com/groupee/forums?m=7166000681&a=tpc&cdr...6088551&f=51060117 51
So, question is, do I just crank on that SOB until it comes out?