Re: AVIC-Z1 install woes
When you say 'looped' the two purple wires, you did leave them connected to the connector as well, and connected a wire between the two purple wires.
Mute output wire from the radio, you did connect that to the cut brown wire that goes to terminal 18 of the PAC adapter? Not sure what would happen if connected to the other terminal of the cut wire.
Red from radio is connected to pin 30 of the relay? This gives you the ignition On input that is normally supplied by the BCM to the factory radio.
Need coffe to think....
__________________
Black Sheep Hummer Squadron
(ME TOO)
Last edited by f5fstop : 07-27-2006 at 02:48 PM.
|