Re: Removing pillar trim.
I'm confused...
Do you mean the upper and lower rear trim panels that contain either a small compartment or a subwoofer?
If so, peal back the rear door weatherstrip and pull the panels out far enough to run wire under them. That is if that is all you want to do is run a wire (or wires). There is no need to completely remove. You might have to remove the rear sill molding, can't remember.
I do know that when I installed the rear camera and ran the wires from there to the front, I only pulled the panels out slightly and fished the wires to the front.
No need to remove the seat belt bolt unless you want to remove the complete panel. Not sure about the six screws?
__________________
Black Sheep Hummer Squadron
(ME TOO)
|