View Single Post
  #30  
Old 05-25-2007, 12:34 PM
HUM GOOD's Avatar
HUM GOOD HUM GOOD is offline
Hummer Professional
 
Join Date: Jul 2005
Location: New Jersey
Posts: 255
HUM GOOD has a little shameless behaviour in the past
Default Re: Trans cooler bursts!

Quote:
Originally Posted by IRA51
from the picture it looks you also remove the small trans cooler and brackets to mount the 4739-1 . and use some the mounting holes of the old trans cooler to mount the 4739 .and than you need to plug all 4 lines to the rad.

Yes replace the smaller cooler with the 4739. I used one hole(top drivers side) from the old cooler. Drilled one new top pass. side. The bottom 2 used brackets that come with the 4739.
As for the radiator. I just by-passed completely. There are 2 lines (one in and one out) they are looped by just clipping the exsisting tubing and looping a short pc of the tubing which comes with the 4739. The 2 lines which came from the rad go to either end of the new cooler(cooler is not directional) this completes the 4739 loop and we are good to go. Very simple.
I found that keeping the connectors in place and clipping the tubing, the supplied rubber hose slid over the exsisting tubing as a perfect fit..
Reply With Quote