Re: 2 Inch Lift on H2.
Mark, I dont think they will vibrate with front height that low. Something is not right. You can count number of "flats" while turning down TBS and see if it goes away - and if that was not it turn the TBs back up exact same number of flats. Make sure to have load off of front end when cranking them up or down. Also, jack each front wheel off ground and grab tire/wheel and try to lift and ot shake the wheel to check for bad hub bearings.. You could also check air pressure and balancing and did you get an alignment after cranking TBs?
__________________
H2 SUT 4.56 Gears, Front Locker, Cognito Pitman/Idler kit & Idler Pivot Kit, Fab Tech Tie Rods, True Tech Trailing Arms, Edelbrock Panhard Rod, PML rear Diff & Tranny Pans, Corsa Exhaust, Dynatech LT Headers, Diablo Predator Programmer, Volant CAI, Warn 9500 Winch, Escort 8500x50 & ZR3 Laser Shifter, Delta Light Bar, Rancho Steering Stabilizer & Bilstein Shocks, Ron Davis Radiator, PowerSlot Rotors, Hawk Brake Pads
|