Quote:
|
Originally Posted by kalantar
Any updates?
|
Yup, sorry, should have kept this going...
Engine and all drivetrain is in and done. Body's on.... (he had to take it off roughly 5 different times to make sure everything fit... and then when he did get it on, he found out he had to pull the body one more time and make new engine mounts, tranny mounts and shorten the driveshaft (again)
He had it in there but felt it would be better if it was one more inch back so he redid it all.
Anyway, he's doing the electrical this week, then he sends it to his buddy who works at a Hummer dealership to make sure all electrical systems function correctly.
Oh, the only other thing is the radiator support. Because you have to basically cut it out and drop it down a few inches, the upper tie bar gets cut to crap.
So he made his own upper tie bar out of stainless and sent it out to get laser cut.
Other than that, shipping will add another 3-4 weeks on to this.
Almost done...
Mark