Re: Headers - Ordered - Discuss install and options
Hey, sorry, haven't checked in for a few days. Yah, you will want to feed them through the bottom, but the challenge is getting the truck up high enough in the air. You can also put them in through the top, but you have to pull some stuff out and take it apart to get them in there. If you don't have a way to get it higher in the air, maybe going through the top would be better.
High flow cats should keep you good to go in OR. I too was concerned about it here in UT as they are anal as all hell with everything on emissions and safety. I almost couldn't pass safety instection because of my tires sticking out the side and my lift; though I have a very mild lift in my opinion. Pisses me off as I see trucks much more lifted than mine driving around without any problems getting registered. Anyway, let me know where you are at with this and I can provide you more detailed help if needed.
__________________
Sweet looking H2 with not enough mods (2003 Pewter H2, 20" Rockstars, 40"x15.5" Toyo MT's, E&G Extended Flares, Full body tube steel exoskeleton, 5" Skyjacker lift, Amp Research steps, Gobi Roofrack and ladders, Smoked LED's, AFe CAI, Dynatech long tubes and cats, Magnaflow exhaust, Stock tune, 4.88 gears, Chrome Grenade Shifter, interior blacked out, rear captains chairs, Solar Power!!)
|