Okay... misleading title. Its not a mount of death, but it is a bit sharp and pointy.
After reading the
Where to mout LEV-O-GAUGE thread I had an idea.
It started with a partition clip. Headliner fabric in the H3 isn't all that different from a cube-a-cage wall, so one of these clips should do it.
I grabbed a few from my office and went to town. 10 minutes later with a bandsaw, a sander, some glue, and a small block of spare maple this is what I had:
And here is the installed result:
No messy adhesive, no screw holes. Once removed no marks are left behind. Not too shabby for 10 minutes labor and some scrap materials. The LEV-O-Gauge hangs esentially verticle and can easilly be moved wherever you feel like it. Just be careful, the pins are sharp.