Bump stop info:
The bump stop has a steel backplate with a single threaded stud and locating tab. It takes about 5 minutes to remove the bump stop.
Ok, I fabbed mine from 2" wide piece of bar stock, 1/2" thick. The 1/2" is probably a little too thick, as you don't completely engage all the threads on the mounting nut...you may want to go 3/8" thick. You'll have to drill two holes for the stud and locating tab.
Now I didn't put a tab on the bar stock spacer, but so far everything has stayed aligned.
To install it, simply jack under the frame until the bump stop clears.
|