Here goes
You pry/remove the original gas well with a plastic putty knife. It just snaps in.
You get a template and drill 5 hole around the edge. You get 5 speed nuts that go in the holes and stop.
There are 4 plastic fingers and 1 metal guide stud.
You light put the unit with the outer bezel on, until it stop. Open the door and from the inside there are 5 holes in the side, use a "L" shape allen wrench and hold each speed nut and put till it snaps to all five. You will know it's seated when the rubber washer around the bezel is flat..easy
|