I just don't get it. Why is the rear height variable?
All the times going in and out of the garage I had the same weight inside the truck yet the rear height varies by about 1.5 inches. Isn't there a sensor that is supposed to put in a predeterined height?
Time to take the trim off the top of the garage door.
<({O})>
Fishing Again.
you could have a rideheight sensor goign bad or soemthing stuck in there. Check your arms to make sure there is nothing around the arm. Also check for play.
you could have a rideheight sensor goign bad or soemthing stuck in there. Check your arms to make sure there is nothing around the arm. Also check for play.
Yeah, I always assumed that the front of the Gobi was highest point on the vehicle. But you are right. I think the suspension must normalize itself with a tolerance of +/- and inch or two. I was very close the first time I drove in. Add an inch and I'm busting the trim. Shouldn't be a huge problem because I'll just remove the trim. The door will look fine and I'll add back the rubber strip.
<({O})>
Fishing Again.
Just don't back into the garage either.
If it has tires or testicles, you're going to have trouble with it
Thread Tools
Search this Thread
Display Modes
Posting Rules