Center console F-ed up

[cecil-1]

My shifter surround/cup holder does not stay in place. The tabs are broken on the console they secure to. Surfing E-bay i found this
http://www.ebay.com/itm/HUMMER-H2-CO...t_27 12wt_902
Anyone have em? How do ya like em?

[[__--MUD--__]]

you will be wetsanding and having to reclear them. All that stock left has signs of shelf wear. But thats no big deal if you know how to do it.

[glennf1]

Just buy the clips at your local dealer and if you want any graphics my friends water transfer shop can do any graphics or carbon fiber look you want fairly inexpensively. Check out their site: www.sourcehydro.com

[cecil-1]

Mud thats good to know. Have ya used any of these? Do they fit close to stock pieces? I've used aftermarket parts that don't fit at all and look like s--t.

Glennf1 Wish I could but my clips on the cup holder are fine. It's the slots they snap into on the console that are gone.

These were going for $232 yesterday when I checked em out. Now they are going for $298 today on the same auction. Is the vendor on this forum? Thats my luck.

[Mister Peebody]

I have them in my SUV. They look great. They are factory replacement part so they fit perfectly. The only issue is that switch hole in the part on the left side of the dash that contains the A/C vent. Don't know what the switch is supposed to be for so I cant even buy one to fill the hole. Also, in the ad it says no air vents included but most of them were in the set I got. Only the rear vents were missing.

[cecil-1]

Thanks for the reply Mister Peebody. I contacted SAE and inquired about the price. They said it was on sale but just went back off. they are shipping me a set at the $232. I can't wait to get em. This cupholder jumping around every time i grab my coffee cup is annoying as hell.

Does anyone know what that switch hole is for? And can ya still get the switch from GM?