Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H1 Discussion Forums > Technical Discussion and Customizing your H1

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 10-26-2005, 02:10 PM
Isakill Isakill is offline
 
Join Date: Oct 2005
Posts: 5
Isakill is off the scale
Default

Hello,
I'm writing in your forum to try and end a debate between me and my fellow Firefighters in my department. We have a Hummer/Hummvee custom made by Fireattacker equipment. The debate verdict will pretty much decide whether we will keep it or not.
The debate is on parts availabilty (Brakes, tires, suspension) and whether the piece of equipment is a Hummer H1 or a military spec Hummvee.
The interior is leather clad and has Hummer on the center of the steering wheel but most ppl in the Department thinks it's a military version.

Getting the obvious things out of the way:

It goes faster than 55 MPH with ease.
The interior.
It has "Park" selection on the tranny
Seatbelts are of a 3-point nature not just lap belts.
12 Volt Charging system

The not so obvious things:

Auto tire Inflation system. (From what I have read this is an option on both the Mil. and Civ. Models)
Water Proofing? I'm not too sure how resistant everything is under the hood. the Mil. is practically waterproof.


The reason I come to you guys for the answer is because Me and a few others are trying to keep it or prove that it's a Civ. Hummer to really put to rest on what parts we can use. Because we need break pads badly.


Thank you,
Ronald Moyer
Van Vol. Fire
Van, WV
Reply With Quote
  #2  
Old 10-26-2005, 02:10 PM
Isakill Isakill is offline
 
Join Date: Oct 2005
Posts: 5
Isakill is off the scale
Default

Hello,
I'm writing in your forum to try and end a debate between me and my fellow Firefighters in my department. We have a Hummer/Hummvee custom made by Fireattacker equipment. The debate verdict will pretty much decide whether we will keep it or not.
The debate is on parts availabilty (Brakes, tires, suspension) and whether the piece of equipment is a Hummer H1 or a military spec Hummvee.
The interior is leather clad and has Hummer on the center of the steering wheel but most ppl in the Department thinks it's a military version.

Getting the obvious things out of the way:

It goes faster than 55 MPH with ease.
The interior.
It has "Park" selection on the tranny
Seatbelts are of a 3-point nature not just lap belts.
12 Volt Charging system

The not so obvious things:

Auto tire Inflation system. (From what I have read this is an option on both the Mil. and Civ. Models)
Water Proofing? I'm not too sure how resistant everything is under the hood. the Mil. is practically waterproof.


The reason I come to you guys for the answer is because Me and a few others are trying to keep it or prove that it's a Civ. Hummer to really put to rest on what parts we can use. Because we need break pads badly.


Thank you,
Ronald Moyer
Van Vol. Fire
Van, WV
Reply With Quote
  #3  
Old 10-26-2005, 05:52 PM
HummBebe HummBebe is offline
Hummer Guru
 
Join Date: Jul 2005
Location: nonpiker
Posts: 5,900
HummBebe is an unknown quantity at this point
Default

Keep it....and POST PICS!

You brave man you

Thank for your service to your community!
Reply With Quote
  #4  
Old 10-26-2005, 05:58 PM
Beastmaster's Avatar
Beastmaster Beastmaster is offline
Hummer Expert
 
Join Date: Jun 2004
Location: Phoenix, AZ
Posts: 605
Beastmaster is off the scale
Default

The list of common vs. uncommon parts are too huge to mention. Here's a short list of parts that are interchangable between Civilian and Military versions.

Some Common parts:
Frame Rails
Body tub
Hood
Bumpers
rims
tires
basic engine block
geared hubs
halfshafts
differentials
primary gas tank
suspension parts
A-Arms
Springs
Shocks

Different parts:
Electrical systems (Civilian is 12v, Military is 24)
Engine Computer (Military generally has none except for the uparmored M1114, Civilian has an engine computer for Emissions control)
TurboCharger (military is generally naturally aspirated save for uparmored versions)
Seats (Well paddded Civilian seats made by Isringhausen, Military is...well, military spec hard seats with minimal padding).
Interior (Military is spare with no noise control padding, Civilian is vinyl with some noise control padding)
Steering Column (Military is straight and non-collapsable. Civilian is collapsable. They are interchangable)
Decapitation brackets (little L Shaped brackets near the windshield frame. Designed to prevent the hood from detaching the upper torso from the rest of the body. Civilian trucks have them, Military does not)

I can (and have) interchanged military parts with my Civilian truck. Works fine. Unless it's electrical or engine computer based, I can pretty much put interchange parts.

It sounds like you have a Civilian H1. Post a pic of the outside (aim the driver's side corner) and the inside (driver's seat and all the controls) and we can verify it. If you post the VIN, I can definitely tell you if it's an H1 or a HMMWV. Civilian trucks will have a VIN plate on the driver's side windshield/top dash area.

Both the H1 and the HMMWV both come off the same assembly line for 2/3'rds of the assembly time. It gets split off towards the end to become either a HMMWV or a Civilian H1.

-Steve
__________________
1997.5 HMC4 Hummer H1 w/Slantback shell (Mine)
2006 Hummer H3 Adv. Package (Wife's)
M101A2 Trailer
Reply With Quote
  #5  
Old 10-26-2005, 06:04 PM
Beastmaster's Avatar
Beastmaster Beastmaster is offline
Hummer Expert
 
Join Date: Jun 2004
Location: Phoenix, AZ
Posts: 605
Beastmaster is off the scale
Default

Oh...to answer your brake pads issue. You'll love this part.

Brake pads are interchangable between Civilian and Military.

I do recommend getting the Hawk Super Duty Brake Pads. http://www.bluehummer.com has them.

Waterproofing - Civilian trucks only are water rated to 30 inches. I've had splash up to the windshield and have had it sitting in water up to the top of the bottom seat cushions, which is about 38-40" of water. As long as the wiring or the engine computer (same level as the AC controls behind the dash) do not get wet and short out, or you don't ingest water (get a snorkel or make one cheap!), it will run while sitting in the water.

Military ones can withstand more water, and with the deep water fording kit and the proper ventilation, you can go underwater (literally) with the military truck.
__________________
1997.5 HMC4 Hummer H1 w/Slantback shell (Mine)
2006 Hummer H3 Adv. Package (Wife's)
M101A2 Trailer
Reply With Quote
  #6  
Old 10-26-2005, 07:06 PM
Isakill Isakill is offline
 
Join Date: Oct 2005
Posts: 5
Isakill is off the scale
Default

Here is a pic of the interior on my son's 3rd B-day. It's the only one I have ATM.
Attached Images
 
Reply With Quote
  #7  
Old 10-26-2005, 08:12 PM
Beastmaster's Avatar
Beastmaster Beastmaster is offline
Hummer Expert
 
Join Date: Jun 2004
Location: Phoenix, AZ
Posts: 605
Beastmaster is off the scale
Default

It's a civilian one. Some major clues:

Park position (you mentioned it already)
AC Controls (the 24v Military AC is an ugly add on but it blows pretty decent cold air)
Gauges are the civilian ones.

On the door post of the driver's door, you'll see an AM General sticker with a VIN code on it. The VIN code should start with 137. If it does, you've definitely got a civilian truck.

The biggest interchangeable parts that you're likely going to end up using would be brake parts, drivetrain parts, some engine parts, some lighting parts, and most of the body.

One interesting question - what model year is it? The easiest way to tell is the VIN sticker has a build date.

The reason why I ask is due to the brake system. Newer trucks (1999 and up) has ABS brakes. If so, there is a major drivetrain component (halfshafts) that is slightly different from the military and pre-99 versions.

-Steve
__________________
1997.5 HMC4 Hummer H1 w/Slantback shell (Mine)
2006 Hummer H3 Adv. Package (Wife's)
M101A2 Trailer
Reply With Quote
  #8  
Old 10-27-2005, 03:13 PM
LAWDOG LAWDOG is offline
 
Join Date: Sep 2005
Location: SO.CALIF
Posts: 43
LAWDOG is off the scale
Default

AND IF IT HAS CUP HOLDERS
Reply With Quote
  #9  
Old 10-27-2005, 07:34 PM
Beastmaster's Avatar
Beastmaster Beastmaster is offline
Hummer Expert
 
Join Date: Jun 2004
Location: Phoenix, AZ
Posts: 605
Beastmaster is off the scale
Default

It looks like a fleet unit. I don't believe there's cupholders in those.
__________________
1997.5 HMC4 Hummer H1 w/Slantback shell (Mine)
2006 Hummer H3 Adv. Package (Wife's)
M101A2 Trailer
Reply With Quote
  #10  
Old 10-28-2005, 10:16 AM
Isakill Isakill is offline
 
Join Date: Oct 2005
Posts: 5
Isakill is off the scale
Default

It has ashtrays!
I have to thank you all for the TREMENDOUS help you have been for me. Not only have you guys proven my point to the department, more importantly you have helped us find an outlet for parts.
Beastmaster, the VIN does start with 137. and I think (I didn't pay full attention) it's either a late 97 or 98 model because we've had it for 8 years. I'll see if I can keep you guys updated on whether or not we sell it.

Thank you
Reply With Quote
  #11  
Old 11-02-2005, 08:59 PM
JnStitz JnStitz is offline
Hummer Veteran
 
Join Date: May 2005
Posts: 113
JnStitz is off the scale
Default

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by Isakill:
It has ashtrays!
I have to thank you all for the TREMENDOUS help you have been for me. Not only have you guys proven my point to the department, more importantly you have helped us find an outlet for parts.
Beastmaster, the VIN does start with 137. and I think (I didn't pay full attention) it's either a late 97 or 98 model because we've had it for 8 years. I'll see if I can keep you guys updated on whether or not we sell it.

Thank you </div></BLOCKQUOTE>

If you do end up selling it, email me.

Thanks!
jnstitz@hotmail.com
__________________
H1 Wagon
Reply With Quote
  #12  
Old 11-07-2005, 11:07 PM
Isakill Isakill is offline
 
Join Date: Oct 2005
Posts: 5
Isakill is off the scale
Default

We decided tonight at our weekly meeting to keep it.

Thank you.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 04:56 AM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.