locking gas cap probs

[HHummer]

Just purchased and installed the Realwheels Billet Aluminum Locking Fuel Door (Black Powder Coated)from the H2Source Store and I am very pleased with the appearance and quality. One note that I would add to the install directions would be concerning the two small screws that hold the cover to the H2 plastic housing. Even with a perfect screwdriver you probably will get a small burr on the screws which would scratch your finish when turning into place at the install to the vehicle. Although it is behind the edge of the cover it would show if you ever removed the cover and returned it to stock. To prevent this, I used a small Dremmel wheel to smooth the screws and placed plastic tape over the entire back edge of the cover and easily trimmed by following the edge with a razor blace. Finally just before turning into place a shot the tape surface with silicone spray. It worked flawlessly and can be removed without any paint damage. Sorry if I bored the pros with this, but thought I may save someone a little disappointment.