TEMPORARY CB install

[H2Finally]

Off-roading only once a month, I decided on a TEMP install. Took me abt 5 minutes to put on/take off from my H2. Kudos to the many prior ideas in this forum.

The CB goes next to right leg. I used 99cents rubber tie-down (a length of thick rubber with s-hooks on each end), to loop around a metal pipe under dash & hooking to driver seat frame. The gap between rubber & console is perfect to hold my CB. I drilled 2 holes in the thick rubber & attached the CB mount (that came with the CB) using screws & bolts.

I enlarged screw hole of the Mic mount (came with CB) & thread through right dash bolt. The black electrical tape is to prevent scratching the dash (eventually to be replaced with those dip-plastic-in-a-can from Home Depot). Power cable run to the back seat power outlet (plug-in). Antenna cable run under mats, under rear seats, under spare tire, out rear hatch..