mounting and wirring driving lights
Ok Ive had my new PIAA 520 ATP driving lights for about 3 weeks now and I havent been able to put them on for a couple reasons. First off my brush guard has no tabs to attach them and Ive found several for 1.25" tube brush gaurds but mine is 1.5". I finally foudn and ordered a set of clap style mounts but the hole in the mount is too small for the bolt on the light. Ive searched online and cant seem to find anything, any suggestions??? Also wirring. I know there are post on here about extra wires to save the step of running a wire though the firewall to a switch and I have located loose wires that seem to stop both under the hood and under the dash as seen here...
Under dash: 
Under hood: 
Are these the wires that can be used to run through the firewall for the switch? and if so which one? I have ordered the Hummer switch for the holes uner the radio, its still in transit. Id like to figure all this out before it gets here and I know the people on here can be a very big help. Thanks for the help in advance.
__________________
06 H3, Boulder Grey (somtimes/mostly just mud, color of mud varies), Leveling Kit, 35" Toyo Open Country M/T's, Westin chrome nerf bar, chrome brush guard, Chrome kit, chrome roof bars, navigation, XM,
brush gaurd lights. Want: 4" or 6" lift, rock rails to replace the steps, roof rack w/lights, want a rack above the spare on rear door, custom seat covers...should be done then but I doubt it 
Last edited by cdmintmi : 06-16-2008 at 03:47 AM.
|
06-16-2008, 03:40 AM
Posting Rules
Threaded Mode