Anyone interested in a REAL HD brushguard?

[HumminNBoatin']

I was supposed to take the H2 to Travis last week just after Windrock but.... I had to do some work to it when I got home, I had an idler arm go bad as well as a ball joint. So in my spare time last week I had to install new Idler/Pitman arms and new ball joints and new grease/dust boots on my Fabtech tie rods as they had rips. And I had to take measurement for some new air spring spacers that I am having made.

So the truck goes back to Travis the second week of November to finish up the BG. He is headed out of town on vacation this week. The hardest part of the designing is done (Taking measurements, building the mount, test fitting, building the front bar, the overhood center loop.) I have seen what he does have done on the truck and I gotta tell you its sweet. Just is taking quiet a bit of time to finish. Once the prototype is done He has to use it to build a Jig for reproduction. Once the Jig is done he has to build a guard on the jig and install it on the truck to be sure the Jig is correct. Then they should be ready for sale.

Along with the guard he is going too be doing a couple other prototypes for the H2 while he has it.