relocate seat heater switches

[timgco]

So, I don't know if anyone else hates this, but reaching down by the door to turn these switches on and off sucks!

My goal is to relocate both switches to the center council, on the sides, in front of the shifter handle. I would like to leave the existing switches in place so no holes are left open.

The new switches I think need a cleaner look. I am thinking of using the switches from the H2 rear seats. It is a much smaller switch and has high, low, and off settings just like the H3 switches do. Does anyone know if those switches will work and what guage wire I will need to extend the existing wires?