This is funny

[RasterMaster]

Any car where you can be in the driver seat and open the passenger door without leaning over is a bit small for me.

<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by Alec W:
WTF are you taking about?<HR></BLOCKQUOTE>

Check out the OkC Chapter Page!

[DennisAJC]

That ones been around Japan for the past 4 years. Over there it's called "Le Cube" or "BB".

I don't see anything funny aboot it. You suck.

[RasterMaster]

Alec,

It's hard to believe somebody was dumb enough to build it, but some fool actually bought that POS!

Check out the OkC Chapter Page!

[Cranky Steve]

<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by Alec W:
I need some help from a toy guy.

This is what I am thinking:

6 inch lift, Dana 40’s front and rear, 33s or 35s (maybe need to get the sawzall out for clearance), rock guards, some skid plates, hack off the front and rear bumper (again sawzall) and we might have a solution?
QUOTE]

I would say get Dana 60's front and rear, with spools. You should also get a crawler. Don't forget that that trick pre-runner bumper.<HR></BLOCKQUOTE>

No prob Alec, here's what you do:

Find a radicly built up early 80's Toy with a SFA and alreadsy equiped with D60's. V8 Swap is preferable

Next, call Hummer Man (If he can do a Boob Job at home, he can fab your Camry onto a truck frame), and have him cut the subframes off the camry and take the body off the truck frame

Now , using JB Weld, mount the camery on the truck frame.

Don't forget the minor details like getting the all the stuff hooked up you need to drive the new rig.


Last but not least, make sure you post the pics .....

Founding Member of RCRC 4wd Club Scaramento, CA www.rcrc4x4.com
Pirate4x4.com Vendor & Toyota Truck and 4Runner Talk Forum Moderator

[Ted]

<BLOCKQUOTE class="ip-ubbcode-quote"><font size="-1">quote:</font><HR>Originally posted by Alec W:
I was thinking Dana 60's might be too much for the Camry frame. Hey, I am not a toy guy though, that's why I asked for advice from the experts. Ya know, I did not even think about a bumper or winch. I do have a fairly big curb; maybe I should install an anchor point near the back gate just in case all this is not enough.<HR></BLOCKQUOTE>
Don't forget the roll cage. If you want to take up too much space in the passenger compartment, you can make an exocage.