got the D1 installed!!!

[MarK M]

I noticed that it took a while for the speed sensor to finally read. But it read.

there was a discussion on here (if you search) about the a-pillar. It's brown when its on the a-pillar side and as it goes down I beleive it changes/splits to ta green wire. If you have a tester, find a green wire along that same harness and put the car in reverse. If you see the change in voltage thats the wire.

As for the Slope... you plugged everything similar to my setup and yet your slop works? DAMIT, I hate you! LOL

[MarK M]

ok, i figured i'd show some pics to verify this pcm and/or bcm plugs.

which plug is the pcm and which is the bcm. Im still having difficulties finding the speed sensor and brake sensor.

[MarK M]

im gonna try the yellow wire as suggested.

[MarK M]

you can pretty much get everything at your local car stereo place except for the double din dash kit.

The only person i know that sells the H3 double din dash kit is kodiakz. Shoot him a PM if you need to get a dash kit.

[MarK M]

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content">Originally posted by BB:
As for speed signal, it's dk grn w/ white of smaller audio connector. </div></BLOCKQUOTE>

Got the passenger kick panel thank you! I'll route that way and let you know.

as for the speed signal. My black radio plug only has two wires from it... pink and orange w/black stripe.

My radio is the basic non bose does that make any difference?

[MarK M]

AVIC-D1 question... for all those that installed the D1, I've been messin' around with the vehicle dynamics feature. Where it shows your the digital speedo, and the two small gauges flanking it.

my question is i got all gauges to work except "SLOPE" it says this function isnt working. Did I not attach a wire? How can I make this work?

thanks,

[MarK M]

i'm completely lost.