Corvette servo install

[guruerror]

Originally Posted by Egan

Installing the Corvette Servo in the H2 tranny:

The idea behind this part is that it firms up the 1-2 shift in our transmissions. For $18 shipped, I figured what the heck and ordered it...

...The installation itself is easy enough and took about an hour....

Egan:

How much tranny fluid did you loose when you popped the servo out?

I guess I'm going to tackle this on Sunday or the next weekend, but wanted to verify how big of a mess it was going to make.

Thanks in advance.

[Hellz]

i havent tried since my first attempt at installing this.

let me know how this goes for you. i couldnt get the lid to push in enough to dig the ring out. i figured there has to be years of grime built up around it.

[Egan]

Originally Posted by guruerror

Egan:

How much tranny fluid did you loose when you popped the servo out?

I guess I'm going to tackle this on Sunday or the next weekend, but wanted to verify how big of a mess it was going to make.

Thanks in advance.

It was just a few drops, maybe a slight dribble for 30 seconds. Not enough that I needed to add any fluid.

[guruerror]

Originally Posted by Egan

It was just a few drops, maybe a slight dribble for 30 seconds. Not enough that I needed to add any fluid.

Sweet...thanks for the quick response.

Originally Posted by Hellz

i havent tried since my first attempt at installing this.

let me know how this goes for you. i couldnt get the lid to push in enough to dig the ring out. i figured there has to be years of grime built up around it.

I'll definitely post back results.

[guruerror]

Originally Posted by Egan

First impressions are a much longer, smoother shift between 1 and 2. I'll reassess after the 12 mile drive to work tomorrow.

What's your long term impressions?

[Egan]

Originally Posted by guruerror

What's your long term impressions?

It's definitely worth the money. With the right amount of throttle the first gear pulls well and shifts smoothly.