Help! I'm Leaking Glub Glub

[Brad]

I would think that a silicone based product would actually help prevent rust.

I know that when new buildings or homes are built they use silicone on all types of substrates to seal it from water penetration.

[TBarrow]

Check with your windshield companies as I was told this years ago. They only use a urethane sealant where it comes in contact with the metal. I have never asked why just been told numerous times even last month when my H2 windshield was replaced.

Black H2 Adventure Series + Luxury, AirForce One intake, Throttle Body Bypass, Gobi Rack w/2" Brackets & 4 PIAA 580 Lights, Xenarc HID, Alcoa Wheels, Goodyear 37x12.50x17 MT/R, Warn 9.5Ti Thermometric Winch, DiabloSport programmer,160 Degree T-Stat, 2-7" screens in headrests with DVD player and TV Tuner.

[cmb31078]

Brad,
I live in North Franklin closer to Green Hills than Franklin. Thanks for the info at the delearship. When I take mine in if I get some guy that is good I will let you know. I also have two friends in town that own H2's also so I will keep us all in the loop.

Cmb

[Brad]

Thanks cmb.

I'LL look forward to hearing from you.

[barbender]

Hard rain last night. My Passenger side carpet is soaked! I pulled up the trim piece by the door and an inch of water sitting there. Two beach towels worth! Back to the dealer tomorrow.

[TBarrow]

Mine is also in the shop coming Monday morning as I to sprung a leak at both grab bars.

Black H2 Adventure Series + Luxury, AirForce One intake, Throttle Body Bypass, Gobi Rack w/2" Brackets & 4 PIAA 580 Lights, Xenarc HID, Alcoa Wheels, Goodyear 37x12.50x17 MT/R, Warn 9.5Ti Thermometric Winch, DiabloSport programmer,160 Degree T-Stat, 2-7" screens in headrests with DVD player and TV Tuner.

[barbender]

T- Thats where the "H2 Oh!" comes out- the grab bars Maybe I should just remove them, haha.

[TBarrow]

Ok mine is fixed. The center lights have a sponge type gasket that had colapsed. they removed the lights and put a urethane seal between them and the truck. There is a tray assembly below the lights that ends about 2.5 - 3 inches from the end and if the lights leak it comes in at the handles. The drivers floor board was damp so the jute was also replaced 15 minutes while I waited for all. I was also experiencing a vibration at higher speeds and it is also now gone.

Black H2 Adventure Series + Luxury, AirForce One intake, Throttle Body Bypass, Gobi Rack w/2" Brackets & 4 PIAA 580 Lights, Xenarc HID, Alcoa Wheels, Goodyear 37x12.50x17 MT/R, Warn 9.5Ti Thermometric Winch, DiabloSport programmer,160 Degree T-Stat, 2-7" screens in headrests with DVD player and TV Tuner.