Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads










 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H2 Discussion Forums > Technical Discussion and Customizing your H2

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 05-08-2004, 03:40 PM
Zing's Avatar
Zing Zing is offline
Hummer Expert
 
Join Date: Nov 2002
Location: NYC
Posts: 884
Zing is off the scale
Default

For those who used the spot right below the windshield wiper switch, after you remove the dashboard panel, then undo the screws, how do you get that piece out? Something is holding it together I can't figure out.

Also, there seems to be hardware right where the switch would go. I remember someone saying (I think it was Phil D) that they had to take about the windshield wiper switch. Any details or insight would be appreciated.
__________________
H2 '04 Black
Reply With Quote
  #2  
Old 05-08-2004, 03:40 PM
Zing's Avatar
Zing Zing is offline
Hummer Expert
 
Join Date: Nov 2002
Location: NYC
Posts: 884
Zing is off the scale
Default

For those who used the spot right below the windshield wiper switch, after you remove the dashboard panel, then undo the screws, how do you get that piece out? Something is holding it together I can't figure out.

Also, there seems to be hardware right where the switch would go. I remember someone saying (I think it was Phil D) that they had to take about the windshield wiper switch. Any details or insight would be appreciated.
__________________
H2 '04 Black
Reply With Quote
  #3  
Old 05-08-2004, 03:40 PM
Zing's Avatar
Zing Zing is offline
Hummer Expert
 
Join Date: Nov 2002
Location: NYC
Posts: 884
Zing is off the scale
Default

For those who used the spot right below the windshield wiper switch, after you remove the dashboard panel, then undo the screws, how do you get that piece out? Something is holding it together I can't figure out.

Also, there seems to be hardware right where the switch would go. I remember someone saying (I think it was Phil D) that they had to take about the windshield wiper switch. Any details or insight would be appreciated.
__________________
H2 '04 Black
Reply With Quote
  #4  
Old 05-08-2004, 05:15 PM
Spike Spike is offline
Hummer Guru
 
Join Date: Oct 2003
Location: Whereabouts unknown
Posts: 2,267
Spike is an unknown quantity at this point
Default

Zing,
I just wired up my roof rack off road lights in December and I installed my switch in the blank under the rear wiper. Is this what you are talking about doing?
Attached Images
 
Reply With Quote
  #5  
Old 05-08-2004, 05:18 PM
Spike Spike is offline
Hummer Guru
 
Join Date: Oct 2003
Location: Whereabouts unknown
Posts: 2,267
Spike is an unknown quantity at this point
Default

Zing,
If that is in fact what you are trying to do meet me on our camping PM and give me your phone number and I'll walk you throught it. It's a little complicated but not impossible. You just have to take your time when you are pulling the wiper housing apart because the contents, knob and stuff will fall out if you don't hold it all together while seperating the 2 shells. Also before you drill the hole I have a tip to make sure it is centered. If you do it after the dash cover is off it will be centered on the blank but not in the dash opening. Leave me your number with a good time to call you.
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 04:02 PM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.