anyone install a timbren kit on their h2?

[kalantar]

I was told this is a good solution for pulling heavy loads and reducing rear end sagging, where as airbags have a 1000 lb capacity this has a 8600 lb capacity. Basically you removed the factory bump stump (which gives 4-6 inches of play) and replace with the timbren kit which only gives 1/2 inch of play. My main concern is that it will give a rough ride but the maufacturer says it wont be effected at all.


http://www.truckspring.com/timbren_285.html

Any thoughts?

[Camou2]

Yes, on a 1/2 ton truck several years ago. When empty they will beat the crap out of you. Work pretty well when loaded. I certainly would not put them on my H2. Try to find an air lift system. Much better solution.

[HumminNBoatin']

Do you have the Factory Air Ride suspension?

There is a similar system out there that allows you to put air bags inside of coil springs that guys have had allot of luck with. U just inflate the air bags via shraider valve when hauling a heavy load. Tomp is very familiar with this set up.

[HumminNBoatin']

Do you have the Factory Air Ride suspension?

There is a similar system out there that allows you to put air bags inside of coil springs that guys have had allot of luck with. U just inflate the air bags via shraider valve when hauling a heavy load. Tomp is very familiar with this set up.

[kalantar]

I have the regular suspension, is there a link?

[Camou2]

Try sdtrucksprings.com They used to have a really cool set of air bags for the H2

[Astroboy]

"Air Lift 1000"
http://shop.airliftcompany.cust.shop...00_Coil_Spring

I have these installed augmenting my coil springs.

I just inflate them with a bicycle-pump when I need to tow a heavy trailer.

[Bimmer9938]

I have used Timbrens on vehicles, I don't think people know what you are talking about. They do not affect the ride at all with no load. They are basically a giant bump stop.