Does anyone know which wire I can get a speed pulse signal from ?

Does anyone know which wire I can get a speed pulse signal from ?

a green and white wire. But there may be 2 of them. When I had my Navi installed I was getting and error that there was no Speed pulse signal. The installer fixed it and said they were to tap into a green and white wire; there were two of them and they had chosen the wrong one. (too bad for me they didn't at least test the system out after the installed it.)

Lucci, I would appreciate if you could tell me exactly where those green and white wires are located. Are they from BCM and PCM ?

See this thread

I used the Yellow Wire
http://elcova.com/groupee/forums/a/tpc/f/2706067735/m/4...761018731#8761018731

<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content"> Lucci, I would appreciate if you could tell me exactly where those green and white wires are located. Are they from BCM and PCM ? </div></BLOCKQUOTE>
I will ask when I drop it off tomorrow evening

Thank you for the information, but I'm confused now. Please help. Do I need to tap into two wires or just one ? What is the difference between VSS High Signal and Low Signal ? Is there any other wires I can get from either BCM or I/P ?

No just 1 the yellow wire. VSS low is the ground side of the circuit

Thanks, h3'er.