Finally finished up an ongoing project to add a switch panel with OTRATTW switches.
I used Bondo Glass to do the bulk of the filling, looked like absolute hell. This was my first time ever taking on a project like this.
After Bondo Glass:
Cleaned up:
After Bondo Glazing and Spot Putty to refine the big imperfections:
All painted up:
Pic of the switches almost wired up completely:
Few pics installed:
Glad it is complete. I jumped the ground wires as the instructions say you can. I also jumped both the positive terminals but the top LED's stay on all the time which is odd since the source is a 12 volt ignition.....something I'm going to play around with.
The 3 right switches are fillers but fully wired with signal wires running to the engine compartment. Basically when I add more mods I'll just order a new switch face and its good to go.