LoJac963's Deuce Build

[LoJac963]

Finally finished up an ongoing project to add a switch panel with OTRATTW switches.

I used Bondo Glass to do the bulk of the filling, looked like absolute hell. This was my first time ever taking on a project like this.

After Bondo Glass:



Cleaned up:



After Bondo Glazing and Spot Putty to refine the big imperfections:



All painted up:



Pic of the switches almost wired up completely:



Few pics installed:





Glad it is complete. I jumped the ground wires as the instructions say you can. I also jumped both the positive terminals but the top LED's stay on all the time which is odd since the source is a 12 volt ignition.....something I'm going to play around with.

The 3 right switches are fillers but fully wired with signal wires running to the engine compartment. Basically when I add more mods I'll just order a new switch face and its good to go.