|
#3
09-20-2005, 08:25 PM
Join Date: Jun 2005
Location: Wisconsin
Posts: 47
a green and white wire. But there may be 2 of them. When I had my Navi installed I was getting and error that there was no Speed pulse signal. The installer fixed it and said they were to tap into a green and white wire; there were two of them and they had chosen the wrong one. (too bad for me they didn't at least test the system out after the installed it.)
#5
09-21-2005, 02:03 PM
Join Date: Aug 2005
Posts: 117
See this thread
I used the Yellow Wire
http://elcova.com/groupee/forums/a/tpc/f/2706067735/m/4...761018731#8761018731
__________________
2006 H3 Birch White,LUX/Adventure PKG,Sunroof,Chrome Pkg,Pioneer AVIC-N2 Navigation/XM Radio
#6
09-22-2005, 12:08 AM
Join Date: Jun 2005
Location: Wisconsin
Posts: 47
<BLOCKQUOTE class="ip-ubbcode-quote"><div class="ip-ubbcode-quote-title">quote:</div><div class="ip-ubbcode-quote-content"> Lucci, I would appreciate if you could tell me exactly where those green and white wires are located. Are they from BCM and PCM ? </div></BLOCKQUOTE>
I will ask when I drop it off tomorrow evening
#7
09-22-2005, 01:56 AM
Hummer Veteran
Join Date: Jun 2005
Location: JAPAN
Posts: 142
Thank you for the information, but I'm confused now. Please help. Do I need to tap into two wires or just one ? What is the difference between VSS High Signal and Low Signal ? Is there any other wires I can get from either BCM or I/P ?
«
Previous Thread
|
Next Thread
»
Thread Tools
Search this Thread
Display Modes
Posting Rules
All times are GMT +1. The time now is 08:39 AM.
Linear Mode
