Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads
















 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H3 Discussion Forums > General H3 Discussion

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #12  
Old 12-30-2005, 12:56 AM
evldave's Avatar
evldave evldave is offline
Hummer Expert
 
Join Date: Oct 2005
Location: somewhere west of north
Posts: 820
evldave is off the scale
Default

hmmm, I'm going to follow the instructions:

Step 1 - Rub the sticker to be sure the transfer tape is properly adhered to the sticker.

Rub what? Where am I supposed to stick her?
---------------------------------------------------------------

Step 2 - Clean and dry the desired area. Stickers will stick best to clean smooth surfaces

Cleaned and dried. I like clean smooth surfaces. What was next?
---------------------------------------------------------------
Step 3 - Remove the paper backing slowly making sure the sticker stays adhered to the transparent transfer tape.

I don't understand. I'm supposed to slowly back up the sticker and adhere it to the transparent what?

-------------------------------------------------------------------
Step 4 - Carefully position the sticker to the desired area. Once the sticker sticks it will be nearly impossible to reposition without destroying the sticker. Rub the sticker from one side to the other, eliminating any air bubbles.

OK! More instructions. Here we go...I positioned the stick her to my desired area. I can't repostion it, but rubbing it seems to make it remove any bubbles. This must be working!
-----------------------------------------------------------------

Step 5 - Use a hard edged object like a credit card to make sure the entire sticker is fully adhered to the surface.

Hard edged object? CHECK!
--------------------------------------------------------------

Step 6 - Slowly remove the transfer tape. Making sure no part of the sticker remains on the transfer tape.

Removed. Nothing remained after I was done, I even checked the stick her and made sure nothing was left over to prevent any accidents.

------------------------------------------------------------
Step 7 - Check for air bubbles. In most cases air bubbles can be worked to the edge of the sticker, but if not, a pin hole will allow the air out and become virtually invisible, once the bubble is gone.

A PINT HOLE? I learned in high school that was bad! Apparently for this stick her, a pin hole is better. OK, if that's what the instructions say, I'll do it. If I have to...

---------------------------------------------------------



Wow! I need to get me one of these stick hers!
Reply With Quote
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 10:53 AM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.