Noisy Transfer Case??

[Vitaliy]

Crawl under the vehicle and remove the transfer case fluid fill plug. If the fluid is not to the bottom of the fill hole, add fluid (DEXRON III trans fluid) until it starts to flow out of the hole.
Replace the plug to 25 N.m.
Disconnect the electrical connector to the vehicle speed sensor toward the top of the transfer case.
Remove the speed sensor from the transfer case.
Add 250 ml (exactly 250 ml) of DEXRON III trans fluid through the speed sensor hole in the case.
Install the speed sensor, tighten to 17 N.m.
All done...

This process is due to the fact that the fill procedure for the case was revised after the first 5000 or so H3s were shipped.
Dealer is supposed to do this procedure before it is sold, and to put an owner's manual update sheet in the owner's manual package.[/quote]
Thanks a lot,
I will do that this Monday.
Vitaliy.