Factory hard tonneau cover (SUT)

[Agriv8r]

Originally Posted by GLBLWARMR

6 bolts. Remove the 3 hex head bolts at the base of the shock on the left side, then just loosen the 3 on the right. The whole lid disconnects. Takes all of 5 minutes. Just did it yesterday. Doing it this way leaves the rails in place and you don't lose the alignment. Then just set the lid back on and retighten.

clever, but you have to be aware of the rails as you use the bed. we had someone do this and was loading cinder blocks, kinked the rail (bent at about 90 degrees) and went without the cover for quite awhile till we could locate one rail for him. but this will work.

[CONRAD II]

Great call on the tonneau cover removal! I'll give it a shot, haven't taken mine off since I bought the friggan thing. Can't wait to have the OPEN cabin again!