New??? side steps

[KenP]

That makes me want to do some measuring.

[Alan06SUT]

Originally Posted by KenP

That makes me want to do some measuring.

X2 I looked at a Pacific Blue one at the dealership and I firmly belive I couldget them on there w/ the stock rockers. Phil D what do you think? Do you have these at TrailDuty?

[tomp]

Looking closely at the LE H2s, it looks as if they not only come with the rocker step and flares with cut-out, but also with the wider flares from this company: http://www.elcovaforums.com/forums/s...ad.php?t=18438

[KenP]

Originally Posted by tomp

Looking closely at the LE H2s, it looks as if they not only come with the rocker step and flares with cut-out, but also with the wider flares from this company: http://www.elcovaforums.com/forums/s...ad.php?t=18438

Frankly, I don't care about the flares. I'm talking about the steps and whether or not they'll fit on the stock rockers.

I'm close to putting money on them fitting.

I'm going to see agriv8r tomorrow and find out.

[tomp]

BTW Ken, they WILL fit without rocker panel cutouts. This was discussed a couple months ago here and a dealer replied that he has done it.

[DDWH]

I looked at them at the dealer aswell....and it looks like it will fit for sure! Plus like tomp said, some dealer guy here has done it. I don't care about the cutout rocker crap, just wanted the steps.

[Agriv8r]

after carefull measuring (100 degrees outside, ran out ran in) I think the gap between the flares and rocker bar on the non LE trucks is slightly smaller, 1/8 inch or so. I do think that you could get away with just the steps aftercutting out the inside of the flare (the part you cant see. After this, the step would sit about 1 inch under the flare, but no reason it could not be done in a few minutes. On the LE it bolts on using the rocker bar monting screws. I have parts investigating just getting the step. will let you know.

[Agriv8r]

and my cost on the steps is about 150 a step...you do the install....add tax....(dealer math) should be close to 7000 dollars give or take...haha no really, 150 a step plus tax...

[KenP]

Originally Posted by Agriv8r

after carefull measuring (100 degrees outside, ran out ran in) I think the gap between the flares and rocker bar on the non LE trucks is slightly smaller, 1/8 inch or so. I do think that you could get away with just the steps aftercutting out the inside of the flare (the part you cant see. After this, the step would sit about 1 inch under the flare, but no reason it could not be done in a few minutes. On the LE it bolts on using the rocker bar monting screws. I have parts investigating just getting the step. will let you know.

Thanks Chuck. Obviously I didn't get over there today because only a fool would be out in that nasty heat.

On now it's thundering and lightning and I'm skeered. That goodness the dog is protecting me.