![]() |
Re: Factory hard tonneau cover (SUT)
I tried this yesterday. Took all of 10 minutes total to remove and put back on! Great tip!
2005 H2 SUT Lux *sold*
Re: Factory hard tonneau cover (SUT)
thanx
Re: Factory hard tonneau cover (SUT)
No worries. I have taken it off and on a couple times over the last couple weeks since I have been moving. Right now waiting to get internet back up and running but that won't be until the 24th. Having to use the computers at the local library to do anything. OCEANIC TIME WARNER CABLE SUCKS.
2006 H2 w/6 inch lift.
2001 F-350 w/10 inch lift
2013 Jeep Wrangler w/6 inch lift
2013 Victory Cross Country
2006 Suzuki Hayabusa
Re: Factory hard tonneau cover (SUT)
It is so nice being able to "use" the back bed now. 2 folding chairs fit perfectly.
I would imagine it will only be a 5-10 minute job to reinstall it. This method doesnt mess with the rails at all so you are not messing with the hard part.
Re: Factory hard tonneau cover (SUT)
Tools: #4 Metric Allen Wrench, 11mm Long Socket and rachet, 11mm open end wrench.
I had a few struggles in the beginning. My bolts were a locked up and required the Allen wrench to bend a little.
As others have stated but in more detail:
The bracket the bolts to do not have holes but rather slots that are open toward the inside, this is why you only have to remove the driver side bolts or actually just the washer and lock nut. I removed the two rear bolts and nut since I didn't want to lose them. I was unable to remove the front bolt, the hatch does not allow enough clearance. By moving the driver side this will allow the passenger side to slide out when you lift the driver side up.
Drivers Side:
Removed the rear two bolts completly. I had to leave the front bolt in since the hatch would not allow me to pull it out. I just removed the nut and washer.
Passenger Side:
There is very little clearance underneath so I just used the deep socket and held it with my hands. Just loosen the three bolts 1/2 turn with the allen wrench.
Removal of Cover:
Lift Driver side of hatch up, pull complete hatch about 8" toward the rear (to clear the side pillars). Move hatch towards drivers side until passenger side clears. Be careful not to let the passenger side fall into the bed. The hatch is ackward but one person can manage it.
My rubber stripping pealed up so I will have to re-adhere when I reinstall the hatch.
I also will buy new bolts since the HEX head was a little torn up and since I was missing two washers I suspect the top had been off.
I removed the hatch to load a 50" plasma TV but can see myself doing this as needed. It is a very easy process.
Search Words: tonneau, bed, cover, remove
had '05 H2 SUT, LUX, Desert Sand
Had '05 Desert Sand H2 LUX
Had '05 Red Metallic H2 ADV
Thread Tools
Search this Thread
Display Modes
Posting Rules