Auto Fold Mirrors?

[dеiтайожни]

Originally Posted by H2Finally

Oh, I see how it is.

[H2Finally]

Lol! Not dishing you dei. Just that where/which wires "that grounds when locked via remote" and to "hook it up at the (mirror fold) switch", are exactly the questions -- for ConradII..

[JamesT]

Crap! They fold in?

[dеiтайожни]

Originally Posted by H2Finally

Lol! Not dishing you dei. Just that where/which wires "that grounds when locked via remote" and to "hook it up at the (mirror fold) switch", are exactly the questions -- for ConradII..

Yeah, yeah! That's what a multimeter is for. Not having an h2, the only thing I could think of is to reverse the polarity of the lt. green wire (factory disarm) in the drivers door module in door to get your ground when armed w/factory. And you just hook one wire up to one wire that goes to the mirror at the switch and the other to the other one. Simple! But you can wait for conrad to make sure.

[H2Finally]

btt. Conrad?

[lonePalm]

Is this for the factory keyless entry system?

[KenP]

I like the one on the left.

[HummBob]

Originally Posted by KenP

I like the one on the left.

X2

[AK47]

Originally Posted by lonePalm

Is this for the factory keyless entry system?

Hi Second on left for me

[AK47]

Originally Posted by lonePalm

Is this for the factory keyless entry system?

**** i dont like i want the second on the left please

[tazhog54]

Must be something wrong with my remotes!! You must have goten the deluxe models

[lonePalm]

I hope someone can get the wiring diagram for these auto folding mirrors, My mirrors would get stuck and not fold in due to the loss of grease in the swivel part, I'm going to drill a small hole and add a grease fitting so every 6 mos I can add some grease. If you go through car washes there is no gasket between the swivel and stationary part, once water starts to get in it there is an E clip that is steel. The E clip starts to rust and there is no grease in it and then it siezes but still makes a noise and alot of people think there mirrors need replaced because they think the gears are stripped. It's easier for the dealership to tell to replace them but very costly. I"ll try to get some pics of the grease fitting procedure. Everything works beautiful now...