Allignment Problem??

[f5fstop]

More likely cause, if there is one, is the tires. Switch them and see if the pull goes to the other side.
However, if there is a slight pull to the right, the alignment shop maybe compensating for a left road crown.

Now, in regard to the runway. Are you sure there is no crown to one side or the other? If no crown, water will pool on the concrete. It might be a slight crown, but I would think there is one to help water runoff.

[ROADNOTCA]

Pull may be different than light throttle drift. I know original Minis and Austin Americas pulled right, don't know about first generation K5 blazers with fulltime 4WD. Of course OR one can't tell.

[marin8703]

Originally Posted by f5fstop

Now, in regard to the runway. Are you sure there is no crown to one side or the other? If no crown, water will pool on the concrete. It might be a slight crown, but I would think there is one to help water runoff.

as always you know your stuff f5fstop. I didnt even think about that. I dont remember but i dont think the runway was grooved so as you say it must have been either rounded overall or had a crown. Im gonna check which one it is. I tried traking the center of the runway, so if its rounded my results could still have some marginal results.

However if it has a crown to one side or the other which is very likely, then those results would be BS.

Thanks for pointing that out, cant beleive i overlooked that , and thanks for everyones responses!