Question for frequent wheelers

[johndjmix1]

I bent that tubeular guard behind the skid plate. I bent it up ever so slightly, which makes it just barley contact the exhuaust pipe making a very loud, bad sounding rattle at times that was VERY difficult to pinpoint. Harmless, but its driving me nuts!!!

--John

[CO Hummer]

Originally Posted by johndjmix1

I bent that tubeular guard behind the skid plate. I bent it up ever so slightly, which makes it just barley contact the exhuaust pipe making a very loud, bad sounding rattle at times that was VERY difficult to pinpoint. Harmless, but its driving me nuts!!!

--John

You know, you have built in cage straightener. Take the cage off, drive over it with the h2, put in back on. Also, you can use some washers on the rear to get more clearance away from the frame.

[h2co-pilot]

1.)There is only 10,000 miles on Big Nasty and we have replaced a lot, CV joint, centerlink, Pitman and idlers, t-case and tierods etc...

But a lot of it is due to the lift and bulkier tires we got installed the same week of purchase.

2.)Our old one had more miles but many electrical problems and the cooling fan blades torn apart after some running through big puddles at Paragon.

But that one was supercharged by by Lingenfelter. They changed a lot of stuff out. I think it was just too many hands in the engine leading to MacGyver like fixes on the trail.

http://www.lingenfelter.com/pack_suv_500h2.htm

So we never really had a normal one.

No real body damage but the occasional tree bite, but I have seen it on other H2's. Which can be costly. Or you could be like Adam and Paragon and not fix it because you know there will be more.


I think for a stock H2 the most wear and tear would be on the IFS and to plan accordingly with regular alignments/a look underneath (which we always do after a trip) and carry extra tie-rods. Grease what you can and keep up with recommended maintenance and invest in some off-road protection accessories.

[GLBLWARMR]

Originally Posted by h2co-pilot

No real body damage but the occasional tree bite, but I have seen it on other H2's. Which can be costly. Or you could be like Adam and Paragon and not fix it because you know there will be more.

Well fixing the body damage would be like getting a tattoo and then going and having it removed just doesn't make sense. Cannot take away from the trucks character. You know like they always say "Chicks dig scars".

As far as the orginal question. With heavy off-road us there are going to be things that are going to need to be replaced more frequently. Alot of this comes down to how you wheel. If you are smart about things then alot of extra maintanence can be avoided but there are going to be times when things just go snap. If you do not like the tree bites there are the body protection panels out there to help with the issue.

[Adam in CO]

Whoa. 55k miles and I have spent AT LEAST 30 grand of the extended warranty company's money thus far.

[Arizona Hummerboy]

I have a 03, and I am at 60,000 miles on it. I have wheel it a lot with out any damage to it, and I have not had any maintenance problems with it form off roading it.

As for maintenance on the Hummer I just try to follow the Owner Manual for maintenance on it.

[CO Hummer]

I've had mine for just about 4 years. Almost $0.00 in maintenace thus far. I only have 35K miles, but I've got a lot of them offroad and no problems so far.

[BlueTJCO]

...in the 130,000 miles I've wheeled her, maybe $20.00 on trail repairs...

[DennisAJC]

Originally Posted by CO Hummer

I've had mine for just about 4 years. Almost $0.00 in maintenace thus far. I only have 35K miles, but I've got a lot of them offroad and no problems so far.

X2

[SnakeH2]

Originally Posted by CO Hummer

I've had mine for just about 4 years. Almost $0.00 in maintenace thus far. I only have 35K miles, but I've got a lot of them offroad and no problems so far.

I am to conclude....good driver = $0.00 Damage

[Boar-Ral]

We go wheeling several times per year and have found that if you are careful, you can avoid mechanical damage. The first thing is to drive slow, where possible, and to be careful with the stock tie rod ends. There are a couple times where the wheels have been stuck, and just tugging a bit on the steering wheel, you can hear a very metallic groaning and clunking sound, and I lay off immediately. So far, we have had no mechanical problems with the vehicle, at around 85,000 km. Now cosmetic damage, that is a differrent story, and I am looking at about $5,000 in repairs, if I decide to go ahead with them.

[BlueTJCO]

Originally Posted by Boar-Ral

We go wheeling several times per year and have found that if you are careful, you can avoid mechanical damage. The first thing is to drive slow, where possible, and to be careful with the stock tie rod ends. There are a couple times where the wheels have been stuck, and just tugging a bit on the steering wheel, you can hear a very metallic groaning and clunking sound, and I lay off immediately. So far, we have had no mechanical problems with the vehicle, at around 85,000 km. Now cosmetic damage, that is a differrent story, and I am looking at about $5,000 in repairs, if I decide to go ahead with them.

[PARAGON]

Originally Posted by CO Hummer

You know, you have built in cage straightener. Take the cage off, drive over it with the h2, put in back on. Also, you can use some washers on the rear to get more clearance away from the frame.

x2 on the cage straightener. Used with a good 4x4 and it works well. Works great for the skid plate as well if you take your time and use 2 pieces of wood.

Be careful with the washers, though. That metal is soft that the bolts screw into and strip out very easily. Not enough threads up in there and it will surely get pulled out.

I lost the center one in the back because the UCP bent way up and acted like a pry bar on the bolt and stripped it all the way out.