Air ride sensor mod made easy!

[Bully13]

Originally Posted by rusty

has anyone run 37x13.5s after doing this mod or similar and not had probs w/ the air sensor?

Got the tires a few days ago. So far there is a little bit of rubbing at full crank. It's not bad. H2 Bully will pics soon. We gottem... Now we just have to go wheeling with them.

[Dug]

I think you could heat the arm with a torch and bend the arm over a 1/2" . Thus not needing to break out your monkey wrench. And leaving time enough in your schedule for a Bud pounder.

[drmiles]

This would work but would shorten the rod (really increase the distance between the two connections) Thus pulling down on the sensor arm and causing the truck to sit lower in the rear!

Originally Posted by Dug

I think you could heat the arm with a torch and bend the arm over a 1/2" . Thus not needing to break out your monkey wrench. And leaving time enough in your schedule for a Bud pounder.

[drmiles]

I guess you could bend the arm in and up which would cause the computer to raise the rear.

Wow rear air, lift kit, one propane torch and a little bending

[rusty]

well thanks for the response dr, i guess it will take a couple of months for me to wear down my 12.50s and try it, but im excited already

[Boston Hummer]

Dose anyone know if you can bypass the airbags and install coil springs?

[Boston Hummer]

So all ya need is the 2 springs and the 4 isolator pads? Then take out the air compressor, anyone know how to trip the sensor so the idots lights don't come on?