I want this bumper!!!

[Crash ?]

Someone posted a link to ebay for a bumper similar to that (without the winch) that they were making and selling.. It wasn't much of a looker, just black and square (like those old bumpers dealers USED to put on P/U's for free), but it looked like it would give better departure angles as well as being tough enough to take a little dragging..

[garnerbiker]

Rob, that's what I want. The greater departure angle would be great.

If anyone has a pic of the one from E-bay, post it up.

The swingarm carrier is what I want to go with. I want the rear tire off center and having room for 2 J cans and HL Jack on the side. Also, with the incresed departure angle, It would be great to have the spare a little higher up too.

[stagger_lee]

Originally Posted by garnerbiker

The swingarm carrier is what I want to go with. I want the rear tire off center and having room for 2 J cans and HL Jack on the side. Also, with the incresed departure angle, It would be great to have the spare a little higher up too.

I agree. I definately want the weight off my rear door, and always have preferred the swing out tire carrier. Off set looks great too.

[Crash ?]

Check out this one..
http://www.teakatoys.com/H3_Deluxe_R...p/db0600h3.htm

Although it looks like it sticks out far enough it may actually cut into your departure angles...

[stagger_lee]

Originally Posted by Crash ?

Check out this one..
http://www.teakatoys.com/H3_Deluxe_R...p/db0600h3.htm

Although it looks like it sticks out far enough it may actually cut into your departure angles...

...and no swing out tire mount and off set spare.
They dont make one like we want. I have looked everywhere. There is a shop by my house here that said the could take one for another vehicle and mod it to fit ours, but thats the only option we have outside of a total custom job.