STORAGE BOX FOR H3

[FJD]

Don't expect these to fit guys!!!

I just had my buddy make a custom one for me and the specs I have doesn't allow for these boxes to fit.

My specs were:
40" wide x 26" deep x 10" high. There is a little extra room around it but I don't see how you're going to get the "mid-size" in there with a 32.5" depth or the "full-size" at 45.5" wide.

Just don't see it fitting in there based on the dimensions I measured but, good luck !!

[RubHer Yellow Ducky]

Are the BACK VERTICAL Pieces of the ready made boxes at 90 degree (straight up and down) or do the slope out at the bottom to match the seat back ????

[Gunner_45]

Just got back from checking......

$%@^&$%#$!!$$% ! ! ! ! ! ! ! ! !

Son of A ??????..

The d@mn thing is about 3.5 inches too deep.

Deck measurements are fine,

However, when measuring a foot off the deck, between
the rear seat back and inside of the (closed) hatch, you get 29 inches.

Even with the rubber mat and carpet removed, you only gain another inch of clearance.
The slant of the seats and the thickness of the hatch are what did me in.

(for the record, I would have double checked prior to ordering and should have done that prior to posting as well....double dumb ass on me)

Damn?.that is both disappointing and embarrassing.......

Man?that really brings the suck.

Sorry to waste ya?lls time.

Good to know. Thanks for doing the research and homework for us.

[fourfourto]

I must have rough measured the High side with the hatch open .
I feel stupid

[Wisha Haddan H3]

Originally Posted by Gunner_45

The d@mn thing is about 3.5 inches too deep.

Deck measurements are fine,

However, when measuring a foot off the deck, between
the rear seat back and inside of the (closed) hatch, you get 29 inches.

Even with the rubber mat and carpet removed, you only gain another inch of clearance.
The slant of the seats and the thickness of the hatch are what did me in.

Sorry to hear about that gunner ... hope you can send it back.

So what were the actual dimensions of the cargo area on the deck and at seat height ... I want to add them to the FAQ

[H3.007]

I wouldn't feel bad about the oversite... tis why we are all here. I am glad I caught the specs and remembered what I had to work with for the rack. For that fact, I am glad I saved you the money.

I wonder if there would be a way to shorten that product ....