Underbody protection install

[jdrew]

im missing the 2 extra bolts in the packing..

[HummBebe]

You might have them backwards. I think the front are longer than the back.

[deserth3]

Originally Posted by jdrew

im missing the 2 extra bolts in the packing..

Sounds that way. Those 2 bolts are longer. If I remember right there should also be a spacer and a normal size bolt with a nut. Also make sure you got the instructions.

[NEOCON1]

there is a spacer bar ( short steel bar ) . i had to leave mine pretty loose and beat some stuff with a sledge hammer to get where all would start . after all bolts are in then tighten it up . a milk-crate works good to help hold it up while getting everything aligned and bolts started .good luck it can be pretty tough

[usetosellhummer]

If I wanted to show my welder friend a diagram of one so he could make it. wehre do you think I may find it.

[jdrew]

Thanks for the replies... I was missing the bolys from the get-go.. i looked on the instructions and i was supposed to get 2 mx38 bolts.. i ran to chev and they had some.. so all good... bring on the rocks..lol

[Crash ?]

Yeah they are a PITA to get on... I spent about 3 hours trying to figure it all out.. I bought a set off a rack at the shop, no instructions, no bolts..

I started in the back and worked my way forward.. I had to use a jack under the front part of the skid plate to get up pressed up enough the bolts would grab...