BLACKSHEEP HUMMER SQUADRON 2007

[The Green Lantern]

INSTRUCTIONS FOR APPLYING DECALS
APPLICATION USING WET TRANSFER METHOD

The surface must be clean and free from oils, waxes and dirt in order for the decal to adhere properly. Mix a solution of water, and dish soap (a few drops to a gallon of water). Use a spray bottle and wet the area where decal will be applied. When the decal is in its final location use a small squeegee to squeeze the water and detergent solution out from under the decal. Allow 1-5 minutes drying time. Allow plenty of drying time because if solution remains under the decal. If there are any air bubbles under the decal that cannot be worked out to the edge, use a small pin to puncture the bubble and remove the air.

[The Green Lantern]

INSTRUCTIONS FOR APPLYING DECALS
APPLICATION USING WET TRANSFER METHOD

The surface must be clean and free from oils, waxes and dirt in order for the decal to adhere properly. Mix a solution of water, and dish soap (a few drops to a gallon of water). Use a spray bottle and wet the area where decal will be applied. When the decal is in its final location use a small squeegee to squeeze the water and detergent solution out from under the decal. Allow 1-5 minutes drying time. Allow plenty of drying time because if solution remains under the decal. If there are any air bubbles under the decal that cannot be worked out to the edge, use a small pin to puncture the bubble and remove the air.

I'm reposting this for those who doesn't know the proper way to apply the decal. I should of printed this and included in the mail but I forgot....so here it is!!!

cheers!