Hummer Forums by Elcova  
Forums - Home
Source Decals

Source Motors
Custom. Accessories.

H2 Accessories
H3 Accessories
Other Vehicles

H2 Source

H2 Member Photos
H2 Owners Map
H2 Classifieds
H2 Photo Gallery
SUT Photo Gallery
H2 Details

H2 Club

Chapters
Application

H3 Source

H3 Member Photos
H3 Classifieds
H3 Photo Gallery
H3 Owners Map
H3 Details
H3T Concept

H1 Source

H1 Member Photos
H1 Classifieds
H1 Photo Gallery
H1 Details

General Info

Hummer Dealers
Contact
Advertise

Sponsored Ads
















 


Source Motors - custom. accessories.


Go Back   Hummer Forums by Elcova > Hummer H3 Discussion Forums > Technical Discussion and Customizing your H3

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #6  
Old 08-01-2007, 04:19 PM
Viet Nam Vette's Avatar
Viet Nam Vette Viet Nam Vette is offline
Hummer Authority
 
Join Date: Oct 2005
Location: Atlantic City NJ
Posts: 1,453
Viet Nam Vette is an unknown quantity at this point
Default Re: Back-Off

Quote:
Originally Posted by Groundpounder
Since the center back up light was installed to attrace attention to your stopping, the BACK-OFF enlarges the odds of your being seen. With it flashing it looks like your panicing and hitting the brakes several times instead of just once.

WIRE LOCATION
I pulled out the lower right corner of the top portion of the rear door and removed the bottom protion completely. Just below the right corner of the top section is a wire connector which has two large wires going to the rear wipper and two smaller (black and green) wires going to the center light. I tapped into the back ground and split the green for the red and the red with white stripe. The wires are long enough for the little power pack to be secured just to the left of the wire connectors. NOTE; make sure the thing is over far enough to the left so the tab on the lower section will go all the way in and not conflict with it.

Thanks Pounder...

The only thing I'm concerned about is damaging the molding when opening that area up. Do you simply pull down on the panel and it will un clip..??

What is the fastener type..?? A clip..or a ball snap in device..?? Or can I just pry open with a screw driver.

Thanks dude.




Up Date..!! Just ordered one... Nice people..will ship to day...

Last edited by Viet Nam Vette : 08-01-2007 at 07:51 PM.
Reply With Quote
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:40 AM.


Powered by vBulletin Version 3.0.7
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.