|
#2
10-23-2007, 08:42 PM
Hummer Novice
Join Date: Oct 2007
Location: San Jose, CA
Posts: 10
Re: Remove/Replace H3 door handles
Okay, I was able to install one of the SMA door handles on the back door. It took a while, but I got it done and it looks/works great. I tried doing the side doors, but was way too complicated. Anyone knows how to disconnect the electricals connected to the door switches? I couldn't figure it out. Thanks!
Last edited by rv_1022 : 10-24-2007 at 12:57 AM.
#3
10-23-2007, 10:53 PM
Hummer Veteran
Join Date: Jul 2007
Location: Clovis, CA
Posts: 32
Re: Remove/Replace H3 door handles
There is a little tab that you press on the plug. Then just jiggle and pull. On the doors you have to remove the glass. On the front it's just two bolts but you need to slide the window to the position thats lets you get to both bolts. Remove the rubber wipper from the window frame and lift it out. On the rear doors you also need to remove the small quarter glass. As I remember I had to pull the seal around the windows out partially and i believe there was another bolt in the door jam someware. Then I just set the quarter glass on the roof with the rest of the seal still attached to the door. Then it's just like the install on the rear door.
Last edited by waynesoffroad : 10-23-2007 at 11:01 PM.
#4
10-29-2007, 04:39 AM
Hummer Novice
Join Date: Oct 2007
Location: San Jose, CA
Posts: 10
Re: Remove/Replace H3 door handles
Special thanks to 'Waynesoffroad'!! I followed your instructions on how to replaced the door handles for the front and back doors, and was able to do it myself. The SMA billet chrome door handles look much better than the ones GM sells. It took a while, but it was well worth it. Saved lots of money that the dealership would have charged me if they did it. Thanks again!!
«
Previous Thread
|
Next Thread
»
Thread Tools
Search this Thread
Display Modes
Posting Rules
All times are GMT +1. The time now is 10:56 PM.
Hybrid Mode