Factory Amp....Interface

[MVR 155]

I am running the PAC Bose interface currently in both my H2 and Z06.... I added a amp and sub to both vehicles. There is no need to get to the factory amplifier, the interface connects to the back of the factory head unit..... its plug and play and very easy to install. check out www.logjamelectronics.com for some great prices on PAC products, I have ordered quite a few things from them.

[SnakeH2]

The reason I was attempting this from the factory amp was because it was so easy to get at. I thought getting to the head unit was more of a project...

[SnakeH2]

Is this it?

http://www.logjamelectronics.com/pacaoemgm24.html

[SnakeH2]

I have a 2005 and I'm finding some conflict as to what I need. It's one of the following...

PAC C2A GM 24

or

PAC AOEM - GM 24

Any thoughts?

[MVR 155]

I went back to my old email to confirm which model I have its the AOEM-GM24
Getting to the factory head unit was also pretty easy to do. I would think that the 2005-2007 trucks all use the same interface (I know that in 2003 there was no navi and in 2004 a different nav unit was used) since they all have the same head units whether it be Nav or no nav.

Not sure if you even thought about this avenue...... going with a line out converter off of the rear speakers. I would strongly suggest not going this route, I initially did this and I was not getting all of the low frequency through my sub so I ended up ordering the interface.

[Tex_h2]

I added an Amp and Sub, by splicing into the rear speakers and adding a Signal Processor. Works great, with more then enough bass from my Kicker.

[MVR 155]

Originally Posted by Tex_h2

I added an Amp and Sub, by splicing into the rear speakers and adding a Signal Processor. Works great, with more then enough bass from my Kicker.

The cleansweep is nice but its pricey at $200+

The PAC AOEM interface is under $50 and will net the exact same results in this situation since it gets an unmolested signal from behind the head unit.

[Tex_h2]

Originally Posted by Tex_h2

I added an Amp and Sub, by splicing into the rear speakers and adding a Signal Processor. Works great, with more then enough bass from my Kicker.

Sorry, that link wasn't suppose to be activate.....I only paid 100.00 for the Amp and Signal Processor....