Factory Amp....Interface

[MVR 155]

Originally Posted by SnakeH2

MVR, Would the PAC Interface work going into the amp in the center console, or is it just for the head unit. Just wondering, because that would be soooo easy.

Its made to attach (basicall installs between the head unit and existing factory harness) to the rear of the head unit. I highly doubt it would work with the harness at the amplifier.

Getting to the head unit is easy, remove the silver Hex screws (I cut the end off of a cheap allen key with a cut off wheel and used my screw gun since the damn things are like 2 feet long). just tilt the bezel backward and loosen the head unit... only need to slide it out slightly to gain access to the rear, plug in the interface and run your rca's down into the lower part of the dash to the kick panel (whichever side you are gonna run your wires down). I secured the interface on top of the head unit in the void between the titty air vents. Bolt it back up and your done. took me all of about 20 minutes to install.